Datalogic Scanning Jet Manuel d'utilisateur télécharger pdf (Page 37)

USE AND FUNCTIONING

3.3 DATA CAPTURE

To capture data, first of all select the barcode icon on the bottom-right side of the

display and tap the 'Capture' menu item, then proceed with the following directions.

To configure and enable data capture parameters refer to par. 3.6.

3.3.1 Laser Data Capture

To scan barcodes, point the Datalogic Jet™ PDA laser model onto the code from a

distance within the reading range while pressing one of the three SCAN Keys. See

the reading diagrams in par. 5.2 for the reading range of your model.

The lighted band emitted by the laser must completely intercept the barcode as

shown in the figure below. If enabled, the emission of an acoustic signal will indicate

that the scan has taken place correctly.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 105 106

Pas de commentaire

Datalogic Scanning Jet Manuel d'utilisateur Page 37