Datalogic-scanning Modem Manuel d'utilisateur télécharger pdf (Page 11)

DATALOGIC

UK/US

The LEDs signal the STARModem™ functioning, as described in the following

table:

LED DESCRIPTION

Power On Green constant STARModem™ is powered.

TX/RX Yellow blinking STARModem™ is receiving or transmitting data.

Off STARModem™ is working correctly. Status

Red constant

at startup, after firmware upload, it indicates that

the system is working with default configuration.

during normal functioning it signals a wrong

connection to the Host.

Red blinking

it blinks during a programming command

execution. In case of wrong command, it will blink

faster.

It blinks once when STARModem™ radio

transaction fails.

INSTALLATION

STARModem™ can be installed to operate in different positions by means of two

mounting brackets and an adjustable antenna.

The four screw holes (M4 x 5) on the body of the modem are for mechanical fixture.

See "Antenna", "Mounting Brackets" and "Overall Dimensions" at the end of this

Quick Reference Manual for more details.

SYSTEM CONNECTIONS

CAUTION

Connections should always be made with power off!

STARModem™ can be connected to the Host through the dedicated 9-pin female

connector, or by means of an adapter and the Datalogic standard cable

corresponding to the desired interface. In addition, a power supply must be

connected to the power jack provided on the same connector.

See "STARModem™ Cable Pinout" at the end of this Quick Reference Manual for

more details.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 81 82

Pas de commentaire

Datalogic-scanning Modem Manuel d'utilisateur Page 11