Datalogic Scanning MAGELLAN 3200VSI Manuel d'utilisateur télécharger pdf (Page 82)

Data Editing

Magellan

3200VSi

Global Prefix/Suffix

Up to 20 ASCII characters may be added as a prefix (in a position before the bar code data) and/

or as a suffix (in a position following the bar code data) as indicated in

Figure 5-2.

Figure 5-2. Prefix and Suffix Positions

Example: Setting a Prefix

In this example, we’ll set a prefix for all symbologies.

1. Determine which ASCII character(s) are to be added to scanned bar code data. In this

example, we’ll add a dollar sign (‘$’) as a prefix.

2. Scan the START bar code.

3. Scan the SET PREFIX bar code.

4. Reference the

ASCII Chart on the inside back cover of this manual, to find the hex value

assigned to the desired character. The corresponding hex number for the ‘$’ character is

24. To enter this selection code, scan the ‘2’ and ‘4’ bar codes from

Appendix C, Alpha-

Numeric Pad

5. Scan the END bar code once to finish the string, then scan END again to exit Program-

ming Mode.

6. The resulting message string would appear as follows:

Scanned bar code data:12345

Resulting message string output: $12345

NOTE

If all 20 characters will be used in the prefix or suffix, do

not scan the END bar code to finish the string. It is done

automatically.

Prefix SuffixAIM IDLabel ID Label IDBar Code Data

00 - 20 Characters (ASCII)

AND

OR...

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 199 200

Pas de commentaire

Datalogic Scanning MAGELLAN 3200VSI Manuel d'utilisateur Page 82