Datalogic Scanning DS2200 Manuel d'utilisateur télécharger pdf (Page 21)

INSTALLATION

The following figure shows an example of a multidrop configuration between a

Multiplexer and DS2200 scanners.

120 Ohm

max. 1200 m.

RTX485 +

RTX485 -

Three wires + shield

MULTIPLEXER

# 1

DS2200

RTX485+

RTX485-

SGND

# 0

DS2200

# x

(up to 31)

120 Ohm

max. 2 m.

RS485 REF

SHIELD

Figure 6 - DS2200 Multidrop connection to a Multiplexer

2.3.3 Auxiliary Interface - RS232

The auxiliary serial interface is used exclusively for RS232 point-to-point

connections. It is also used for configuring the DS2200.

The parameters relative to the auxiliary interface (baud rate, data bits, etc.) can be

defined using the WinHost utility program or "Host Mode Programming" installed from

the diskette.

The following pins of the 25-pin connector are used to connect the RS232 auxiliary

interface:

Pin Name Function

3 RXAUX RS232 received data

2 TXAUX RS232 transmitted data

7 SGND signal ground

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 40 41

Pas de commentaire

Datalogic Scanning DS2200 Manuel d'utilisateur Page 21