Datalogic-scanning Connection Box C-BOX 150 Manuel d'utilisateur télécharger pdf (Page 20)

C-BOX 150

2.4.3 Scanner Chassis Grounding Jumper Settings

The scanner chassis grounding method can be selected by positioning a jumper (see

Figure 9). In this way the scanner chassis can be connected to earth ground (only if

pins 7 or 8 are connected to a good earth ground) or to the power supply ground

signal. The scanner chassis can also be left floating but, in this case, the jumper

must be removed.

Figure 9 – Chassis Grounding

2.4.4 Scanner Selection

DS1100

DS2200

Other Devices

floating

to EARTH

GROUND

(default)

to GND

Figure 10 - Scanner Selection Switch

This switch must be set upward only when a DS1100 or a DS2200 scanner (10-30 V

version) is connected. For all the other devices the switch must be set downward.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Pas de commentaire

Datalogic-scanning Connection Box C-BOX 150 Manuel d'utilisateur Page 20