Datalogic-scanning Connection Box C-BOX 150 Manuel d'utilisateur télécharger pdf (Page 23)

INSTALLATION

9-pin C-Box 150 connector pinout in Normal mode

Pin Name Function

1 NC

2 RXA Auxiliary RS232

3 TXA Auxiliary RS232

4 NC

5 GND Ground

6 NC

7 RESERVED Device Dependent Signal

8 RESERVED Device Dependent Signal

9 NC

POSITION MODE

CFG: When the switch is in this position, the C-BOX 150 can be

configured. The communication with the scanner is interrupted and pins

2 and 3 are no longer dedicated to the scanner auxiliary interface but to

the C-BOX 150 configuration (see table below). The C-BOX 150 enters

configuration mode and waits to be configured through WinHost (see

WinHost Help On Line).

Once the C-BOX 150 configuration is completed, it is necessary to

return the switch in the Normal Operation position. At the end of the

reboot phase, the C-BOX 150 is ready to function with the new

configuration.

9-pin C-Box 150 connector pinout in Configuration mode

Pin Name Function

2 RX C-BOX 150 Configuration

3 TX C-BOX 150 Configuration

5 SGND Signal Ground

CAUTION

When the C-BOX 150 configuration is completed, remember to

return the Configuration switch in the Normal Operation position.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 33 34

Pas de commentaire

Datalogic-scanning Connection Box C-BOX 150 Manuel d'utilisateur Page 23