Datalogic-scanning C-BOX 300 Manuel d'utilisateur télécharger pdf (Page 15)

INSTALLATION

2.2 OPENING THE DEVICE

To install the C-BOX 3X0 or during normal maintenance, it is necessary to open it by

unscrewing the four cover screws:

CAUTION

The C-BOX 3X0 must be disconnected from the power supply

during this operation.

Figure 2 - Opening the C-BOX 3X0

It is possible to perform the following operations:

• Proceed with the cable connections (see paragraph 2.4.2).

• Set the Profibus node address selection on the rotary switches.

• Mount the C-BOX 3X0 to a wall or panel.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Pas de commentaire

Datalogic-scanning C-BOX 300 Manuel d'utilisateur Page 15