Datalogic-scanning QUICKSCAN 6000 Manuel d'utilisateur télécharger pdf (Page 12)

QuickScan 6000/6000 Plus

Where To Go From Here

Programming is easy and straightforward if you follow these steps:

1. If you are changing interfaces, first connect the scanner to the new host

using the new interface cable. Scan the interface enable bar code label

2. Scan any feature labels that are unique to the interface you are currently

programming. These interface specific programming labels immedi-

ately follow each interface selection label.

3. Turn to the Symbology section if you are going to change any bar code

symbologies or modify any symbology related features.

4. Turn to the General Features section of this guide if you wish to

change or modify any of the scanner's other features.

Once the necessary changes have been made, and you have scanned the END label,

you are ready to scan.

1 This step is not necessary for QuickScan 6000 Plus scanners, unless you require a

specific interface sub-type such as SNI OCIA or IBM sub-type 4682/92 Port E.

Interface software is automatically selected when the QuickScan 6000 Plus hardware

connection (via a new interface cable) is made.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 103 104

Pas de commentaire

Datalogic-scanning QUICKSCAN 6000 Manuel d'utilisateur Page 12