Datalogic-scanning QUICKSCAN 6000 Manuel d'utilisateur télécharger pdf (Page 28)

QuickScan 6000/6000 Plus

This section contains the following PC Keyboard Wedge communication

parameters in the order listed:

Keyboard Wedge Communication Parameters

• Interface Selection

• Connect to Laptop

• Caps lock Settings

• Country modes

• Intercharacter Delay

Go to the sections titled Symbology Selection and General Features in the

back of this programming guide if you want to change any other settings.

NOTE

If the transmission parameters are configured such that a label

results in no actual data to send, the label will be accepted, beeped,

and no data transmitted.

PC Keyboard Wedge Interface Selection

The scanner supports ten

PC Keyboard Wedge interfaces. The table

below defines the different interface selections.

I/F Type PCs Supported

A PC/XT w/Alternate Key Encoding

B AT, PS/2 25-286, 30-286, 50, 50Z, 60, 70, 80, 90 & 95 w/Alternate Key Encoding

C PS/2 25 and 30 w/Alternate Key Encoding

D PC/XT w/Standard Key Encoding

E AT, PS/2 25-286, 30-286, 50, 50Z, 60, 70, 80, 90 & 95 w/Standard Key Encoding

F PS/2 25 and 30 w/Standard Key Encoding

G IBM 3xxx w/122 keyboard

(QuickScan 6000 Plus ONLY)

H IBM 3xxx w/102 keyboard

(QuickScan 6000 Plus ONLY)

I PS/55 5530T w/104 keyboard

(QuickScan 6000 Plus ONLY)

J NEC 9801

(QuickScan 6000 Plus ONLY)

NOTE

We recommend that you disconnect power before plugging/

unplugging cables to avoid any possibility of equipment damage.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 103 104

Pas de commentaire

Datalogic-scanning QUICKSCAN 6000 Manuel d'utilisateur Page 28