Datalogic-scanning QUICKSCAN 6000 Manuel d'utilisateur télécharger pdf (Page 40)

QuickScan 6000/6000 Plus

Setting A Single Character Prefix or Suffix

To set one ASCII character as a prefix or suffix, follow steps one through

four on the previous two pages (select prefix or suffix), then...

1. Scan the two digit Hex Code for that character.

(e.g. 03, 8F, ...FF)

NOTE

If you make a mistake, or lose your place while setting this option,

scan the END label to exit Programming Mode. The scanner will

sound an error tone (six rapid beeps) to indicate that programming

was incomplete, and the setting will remain as it was before

entering Programming Mode.

2. Scan the ONE CHARACTER ONLY label on the following

page.

3. Scan the END label.

You have set a single character prefix or suffix.

Setting Prefix and/or Suffix Characters

NOTE

You must scan the SET label and either the SET PREFIX or SET

SUFFIX label before using the labels on this page.

0 ------------------------------------

1 ------------------------------------

2 ------------------------------------

3 ------------------------------------

4 ------------------------------------

5 ------------------------------------

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 103 104

Pas de commentaire

Datalogic-scanning QUICKSCAN 6000 Manuel d'utilisateur Page 40